8 System Setup
DX100 8.17 Changing the Parameter Setting
8-118
Set the parameters in the following manner.
1. Select the parameter data to be set.
(1) Move the cursor to the parameter number data (decimal or binary)
in the PARAMETER window, and press [SELECT].
(2) To enter a decimal setting, select the decimal figure.
(3) To enter a binary setting, select the binary figure.
2. Enter the value.
– If a decimal figure is selected, enter a decimal value with the
numeric keys.
– If a binary figure is selected, move the cursor to the binary figure
data in the input buffer line, and press [SELECT].
– Each time [SELECT] is pressed, “0” and “1” alternate in the window.
– “0” or “1” can also be entered with the numeric keys.
3. Press [ENTER].
– The new setting appears in the position where the cursor is located.
To Next Page
Loading...
