9 System Backup
DX100 9.1 System Backup with DX100
9-1
9 System Backup
For the DX100, the system data can be collectively backed up in advance
so that the data can be immediately loaded and restored in case of an
unexpected trouble such as data loss.
9.1 System Backup with DX100
For the DX100, four types of collective backup are available: CMOS.BIN,
CMOSBK.BIN, ALCMSxx.HEX, and CMOSxx.HEX.
9.1.1 Function Types of Data
9.1.1.1 CMOS.BIN
For the normal backup, use this data.
Save: Perform in the maintenance mode (the editing mode or higher.)
Load: Perform in the maintenance mode (the management mode.)
As for the load/save procedures, refer to chapter 9.2 “Backup by
CMOS.BIN” at page 9-3.
Target Area: All areas of the internally stored data. (Note that the
monitoring time is not loaded.)
9.1.1.2 CMOSBK.BIN
This data is used in the automatic backup function.
Save: Saves with the preset conditions in the normal mode.
Load: Perform for the system restoration in the maintenance mode (the
management mode.)
For details, refer to chapter 9.5 “Error List” at page 9-20.
Target Area: All areas of the internally stored data. (Note that the
monitoring time is not loaded.)
9.1.1.3 CMOSxx.HEX
This data is loaded/saved in the FD/CF menu in the normal mode.
Save: Perform in the normal mode (the editing mode or higher.)
Load: Perform in the normal mode (the management mode.)
For details, refer to "DX100 OPERATOR’S MANUAL."
Target Area: The collected data including "Job File," "Data File,"
"Parameter File," "System Data," and "I/O Data" which can
be individually loaded/saved in the FD/CF menu. Because
the setting information of robot etc. are not included in this
collected data, the system cannot be completely restored.
9.1.1.4 ALCMSxx.HEX
This data is for the manufacturer only. Users can save but cannot load
this data.
To Next Page
Loading...
