1 Safety
DX100 1.5 Motoman Safety
1-6
CAUTION
MOTOMAN should be lifted with a crane using wire rope threaded
through the shipping bolts and positioners and the body should be lifted
in an upright posture as described in the manipulator instruction
manual.
Failure to observe these precautions may cause the manipulator to turn
downward, potentially causing injury or damage to equipment.
• When lifting the DX100, please check the following:
– As a rule, handling of DX100 must be performed using a crane
with wire rope threaded through attached eyebolts.
– Be sure to use wire that is strong enough to handle the weight of
the DX100.
• Be sure the eyebolts are securely fastened.
Failure to observe this caution may result in injury or damage to
equipment.
• If storing the manipulator temporarily before installation, be sure to
place it on a stable and flat surface and take precautions to prevent
unauthorized personnel from touching it.
Failure to observe this precaution may result in injury of damage to
equipment.
Wire Rope
M16 Eye Bolt
Table 1-1: Approx. Weight of DX100
Models Available for
DX100
Approx. Weight
(kg)
small capacity:
MA1400, MA1900,
VA1400, MH5, MH5L,
MH6, HP20D, HP20D-6
A-Type
(standard)
100
middle/large capacity:
MH50, MS80, ES165D,
ES200D, VS50, SIA50D
A-Type
(standard)
100
To Next Page
Loading...
