9 System Backup
DX100 9.3 Automatic Backup Function
9-14
9.3.2.3 DX100 Status and Automatic Backup
* Retry is not performed when an error occurs.
* An error can be indicated by a message depending on setting.
Reserve Time Backup
While the data in the DX100 memory is being edited or overwritten, the
automatic backup is not performed at the specified backup starting time
and is suspended and retried later. To start the backup at the reserved
time, set to the time when the robot program is stopped and no job or file
is edited.
Backup when Switching from Teach Mode to Play Mode
When the mode is repeatedly switched from the teach mode to the play
mode or vice versa within 1 to 2 seconds, backup starts after the last time
the mode is switched.
Backup when the DX 100 starts up
Since the automatic backup process is added to the DX100 start-up
process, a few extra seconds are needed to start up the DX100.
Backup
Timing
DX100 Status Automatic Backup
Compact
Flash
ready to
save the
data
Absence or
insufficient
capacity of the
CompactFlash
From a
specified
starting time
Teach mode Editing
(Accessing to
the memory)
Retry Retry
When editing is
interrupted
Backup Error
Play mode
Remote mode
Executing jobs Disabled Disabled
When stopped Backup Error
When a
specified
signal(#40560)
is input
Teach mode Editing
(Accessing to
the memory)
Error Error
When editing is
interrupted
Backup Error
Play mode
Remote mode
Executing jobs Disabled Disabled
When stopped Backup Error
When
switching the
mode from the
teach mode to
the play mode
- Backup Error
When the
DX100 starts
up
- Backup Error
To Next Page
Loading...
