10 Upgrade Function
DX100 10.2 Upgrade Procedure
10-3
NOTE
DO NOT turn off the main power supply during automatic
upgrade process.
In case the main power supply is turned off, exercise the
following process.
• Turn on the main power supply of DX100.
– Automatic upgrade might be exercised again.
• In case error occurs during automatic upgrade process.
(1) Prepare CF for upgrading or USB memory.
(2) Press [2], [8] and [HIGH SPEED] at the same time.
-Upgrade of the OS of Programming Pendant
(3) Press [INTERLOCK], [8] and [SELECT] at the
same time.
(4) Exercise manual upgrading.
- Refer to “DX100 Upgrade Procedure”
(HW0485193).
• If no recovery is made with all the procedure above,
replace the pendant.
To Next Page
Loading...
