11 Modification of System Configuration
DX100 11.2 Addition of Base and Station Axes
11-9
– In this example, B1 (Base) is to be connected as shown in the
following manner:
3. Select the desired item.
4. Press [ENTER] in the CONNECTION window.
– The setting in the CONNECTION window is completed and the
window moves to the AXES CONFIG window.
11.2.1.3 Axis Configuration Setting
The axis type is specified in the AXES CONFIG window.
1. Confirm axis type of each axis in the AXES CONFIG window.
– The axis type of each axis is displayed.
2. Select the axis type to be modified.
1st axis SERVO Board (SV #2), Connector (7CN),
Contactor Unit (TU #1), Brake Connector (BRK7),
Converter (CV #1)
2nd
axis
SERVO Board (SV #2), Connector (8CN)
Contactor Unit (TU #1), Brake Connector (BRK8)
Converter (CV #2)
3rd
axis
SERVO Board (SV #2), Connector (9CN)
Contactor Unit (TU #1), Brake Connector (BRK9)
Converter (CV #3)
To Next Page
Loading...
