11 Modification of System Configuration
DX100 11.2 Addition of Base and Station Axes
11-11
– REDUCTION RATIO : Input the numerator and the denominator.
<e.g.> If the reduction ratio is 1/2, the
numerator should be set as 1.0 and the
denominator should be set as 2.0.
– BALL-SCREW PITCH: Input the traveling length when the ball-
screw rotates once. (Unit: mm/r)
The MECHANICAL SPEC window (in case of the RACK&PINION type)
– MOTION RANGE : Input maximum moving position (positive (+)
direction and negative (-) direction) from
home position when setting the home position
to 0. (Unit: mm)
– REDUCTION RATIO: Input the numerator and the denominator.
<e.g.>If the reduction ratio is 1/120, the
numerator should be set as 1.0 and the
denominator should be set as 120.0.
– PINION DIAMETER : Input the diameter of a pinion. (Unit: mm)
2. Select the item to be modified.
– Point the cursor to the item subject for setting value modification,
and press [SELECT].
3. Modify the settings.
– The selected item is in the input status.
Input the setting value, and press [ENTER].
4. Press [ENTER] in the MECHANICAL SPEC window.
– After the setting, the current window moves to the window for the
next axis setting. Complete the settings for all axes in the same
manner.
– When [ENTER] is pressed in the MECHANICAL SPEC window for
the last axis, the setting in the MECHANICAL SPEC window is
completed and the window moves to the MOTOR SPEC window.
Selected group, type, axis no.
and axis type are shown.
To Next Page
Loading...
