11 Modification of System Configuration
DX100 11.2 Addition of Base and Station Axes
11-19
The MECHANICAL SPEC window (In case of the BALL-SCREW type)
– MOTION RANGE : Input maximum moving position (positive (+)
direction and negative (-) direction) from
home position when setting the home
position to 0. (Unit: mm)
– REDUCTION RATIO : Input the numerator and the denominator.
<e.g.> If the reduction ratio is 1/2, the
numerator should be set as 1.0 and the
denominator should be set as 2.0.
– BALL-SCREW PITCH: Input the traveling length when the ball-
screw rotates once. (Unit: mm/r)
The MECHANICAL SPEC window (In case of the RACK&PINION type)
– MOTION RANGE : Input maximum moving position (positive (+)
direction and negative (-) direction) from home
position when setting the home position to 0.
(Unit: mm)
– REDUCTION RATIO: Input the numerator and the denominator.
<e.g.>If the reduction ratio is 1/120, the
numerator should be set as 1.0 and the
denominator should be set as 120.0.
– PINION DIAMETER : Input the diameter of a pinion. (Unit: mm)
Selected group, type, axis no.
and axis type are shown.
Selected group, type, axis no.
and axis type are shown.
To Next Page
Loading...
