YASKAWA DX100 - Connecting the Programming pendant

4 Connection
DX100 4.3 Connection Methods
4-12
4.3.3 Connecting the Programming Pendant
1. Connect the programming pendant cable to the connector on the door
lower right side of the controller cabinet.
Fig. 4-17: Connecting the Programming Pendant
– The manipulator, DX100, and the programming pendant
connections are now complete.
CAUTION
Always close the door of the controller (DX100) except for mainte-
nance.
Make sure to rotate all the door locks counterclockwise.
If dust or water enter inside the controller, electric shock or breakdown
of DX100 may result.
Alignment mark
长沙工控帮教育科技有限公司
工控帮助教小舒QQ:2823408167