5 Turning ON and OFF the Power Supply
DX100 5.1 Turning ON the Main Power Supply
5-1
5 Turning ON and OFF the Power Supply
5.1 Turning ON the Main Power Supply
The main power supply is turned ON when the main power supply switch
on the front of the DX100 is turned to the "ON" position, and the initial
diagnosis and the current position setting begin.
Fig. 5-1: Turning ON the Main Power Supply
WARNING
• Confirm that nobody is present in the P-point maximum envelope of
the manipulator when turning ON the DX100 power supply.
Failure to observe this caution could result in injury caused by
accidental contact with the manipulator.
Press the emergency stop button immediately if any problems occur.
The emergency stop buttons are located on the right side of the front
door of the DX100 and on the right side of the programming pendant.
DX100
ON
TRIPPED
R
E
S
E
T
O
FF
Main power supply switch
To Next Page
Loading...
