5 Turning ON and OFF the Power Supply
DX100 5.2 Turning ON the Servo Power
5-4
SUPPLE
-MENT
Servo Power ON/OFF --- Enable Switch
When the operator grips the Enable switch, the servo power
turns ON. However, if the operator squeezes the switch until
a “click” is heard, the servo power will turn OFF.
NOTE
When performing emergency stop on the front door of the
DX100, programming pendant, or external signal, the servo
power-on operation from the Enable switch is cancelled.
When turning the power back ON, follow the previously
listed instructions.
Release -> OFF
Squeeze Tightly -> OFF
Squeeze -> ON
Servo On
To Next Page
Loading...
