7 Security System
DX100 7.1 Protection Through Security Mode Settings
7-4
SETUP TEACHING COND Edit Edit
OPERATE COND Management Management
DATE/TIME Management Management
GRP COMBINATION
3)
Management Management
RESERVE JOB NAME Edit Edit
USER ID Edit Edit
SET SPEED Management Management
KEY ALLOCATION
1)
Management Management
RES. START (CNCT) Management Management
AUTO BACK SET Management Management
WRONG DATA LOG Operation Management
ARC
WELDING
ARC START COND. Operation Edit
ARC END COND. Operation Edit
ARC AUX COND. Operation Edit
POWER SOURCE COND. Operation Edit
ARC WELD DIAG. Operation Edit
WEAVING Operation Edit
ARC MONITOR
4)
Operation -
ARC MONITOR (SAMPL) Operation -
HANDLING HANDLING DIAGNOSIS Operation Edit
SPOT
WELDING
WELD DIAGNOSIS Operation Edit
I/O ALLOCATION Management Management
GUN CONDITION Management Management
CLEARANCE SETTING Operation Edit
POWER SOURCE COND Management Management
SPOT
WELDING
(MOTOR GUN)
WELD DIAGNOSIS Operation Edit
GUN PRESSURE Edit Edit
PRESSURE Edit Edit
I/O ALLOCATION Management Management
GUN CONDITION Management Management
CLEARANCE SETTING Operation Edit
SPOT POWER
SOURCE COND
Management Management
TIP INSTALLATION Operation Management
GENERAL WEAVING Operation Edit
GENERAL DIAG. Operation Edit
COMMON TO
ALL
APPLICATIONS
I/O VARIABLE CUSTOMIZE Operation Operation
1 Displayed in the teach mode only.
2 It is possible to initialize a floppy at FC1/FC2.
3 Displayed only with two or more control groups.
4 Displayed in the teach mode only.
*Data is cleared in the edit mode or higher.
Table 7-2: Menu & Security Mode (Sheet 3 of 3)
To Next Page
Loading...
