YASKAWA DX100 - Setting the Second Home Position (Check Point)

8 System Setup
DX100 8.2 Setting the Second Home Position (Check Point)
8-11
8.2 Setting the Second Home Position (Check Point)
WARNING
• Be aware of safety hazards when performing the position
confirmation of the second home position (check point).
When "OUT OF RANGE (ABSO DATA)" alarm occurs, abnormality of
the PG system may be a cause of the alarm. The manipulator may
operate in an unexpected manner, and there is a risk of damage to
equipment or injury to personnel.
• Before operating the manipulator, check that the SERVO ON lamp
goes out when the emergency stop buttons on the front door of
DX100 and the programming pendant are pressed.
Injury or damage to machinery may result if the manipulator cannot be
stopped in case of an emergency.
• Observe the following precautions when performing teaching
operations within the P-point maximum envelope of the
manipulator:
– View the manipulator from the front whenever possible.
– Always follow the predetermined operating procedure.
– Ensure that you have a safe place to retreat in case of
emergency.
Improper or unintended manipulator operation may result in injury.
• Prior to performing the following operations, be sure that no one is
in the P-point maximum envelope of the manipulator, and be sure
that you are in a safe place when:
– Turning ON the DX100 power
– Moving the manipulator with the programming pendant
– Running the system in the check mode
– Performing automatic operations
Injury may result from contact with the manipulator if persons enter the
P-point maximum envelope of the manipulator.
Press the emergency stop button immediately whenever there are
problems.
• Emergency stop buttons are attached on the front door of the
DX100 and the right side of the programming pendant.
长沙工控帮教育科技有限公司
工控帮助教小舒QQ:2823408167