9Error
DX100 9.1 Error Message List
9-5
770 - During robot or station operation
780 - Quittance operation by mini operation
pendant
790 - FWD/BWD don't work in the handle
operation
800 - The gun of designation is not
connected
801 - The group axis of designation is not
connection
810 - Servo power supply is limited
820 - Modification range over
830 - Cannot move while modifying speed
840 - Unregistered key
850 - Cannot register instruction
860 - Please release key registration mode
870 - This key cannot be allocated
880 - Same relay cannot be set
890 - This key has already been registered.
Cannot register them once
900 - Relay No. not set
910 - Cannot be registered because job
control group not same
920 - Cannot modify this setting
930 - Undefined conveyor calibration data
940 - Dry spot input signal is ON
950 - Adjustment stroke is negative
960 - I/O axis mode requesting
970 - ERRSVCPU signal error
971 - ERRCPU signal error
980 - TIMER DATA TRANSMISSON
ERROR
Error No. Data Error Message Contents
To Next Page
Loading...
