YASKAWA DX100 - 9.1.6 Maintenance Mode

9Error
DX100 9.1 Error Message List
9-18
9.1.6 Maintenance Mode
Error No. Data Error Message Contents
8010 - Too many axes
8011 - Choose the input of overrun
8012 - Equipment data file reading
error
8020 - Too many I/O points
8021 - YIU Unit not found
8030 - Too many boards (DEVICENET)
8031 - Too many boards (MSC01B)
8032 - Too many Timer I/F board
8033 - Too many boards
8034 - Too many channels
8035 - Invalid configuration
8040 - Memory error (ControlNet output
condition)
8041 - Memory error (UNIWIRE
CONNECT DAT
8042 - Memory error(IP Network
Configuration data)
8050 - Robot model is not registered
8051 - Select model
8060 - Cannot get UNIWIRE
connection data
8070 - DHCP is already set to use for
another item
8071 - DNS is already set to use for
another item
8072 - DHCP is not set to use
8073 - DNS is not set to use
8074 - Device Information not found
8075 - Unable to accept same type of
boards simultaneously
8076 - Ethernet is being used by other
function.
8080 - Non support function