Alarm List
Alarm Number (4000 to 4999)
Alarm List-885
4759 M-SAF ON_ENABLE
DIAG. ERROR
An error is detected by YSF21
board.
The meaning of each sub
code is as follows:
CPU1 1:ON_ENABLE1
CPU1 2:ON_ENABLE2
CPU1 3:ON_ENABLE3
CPU1 4:ON_ENABLE4
CPU2 1:ON_ENABLE1
CPU2 2:ON_ENABLE2
CPU2 3:ON_ENABLE3
CPU2 4:ON_ENABLE4
YSF21 board failure (1)Reset the alarm.
(2)If the alarm occurs again, replace the YSF21 board.
YSF22 board failure (1)Reset the alarm.
(2)If the alarm occurs again, replace the YSF22 board.
In a system where a plurality of YSF22 boards are connected, replace
the board, which is connected to the ON_ENABLE signal on which the
alarm occurred.
Other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
4760 M-SAF FULL SPEED
DIAG. ERROR
Sub code indicates the
process that the software of
CPU1 or CPU2 detected an
error.
YSF21 board failure (1)Reset the alarm.
(2)If the alarm occurs again, replace the YSF21 board.
YSF22 board failure (1)Reset the alarm.
(2)If the alarm occurs again, replace the YSF22 board.
In a system where a plurality of YSF22 boards are connected, replace
the YSF22 board which is connected to the first EAXA21 board.
Other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
Alarm
Number
Alarm Name
Sub
Code
Meaning Cause Remedy
To Next Page
Loading...
