Alarm List
Alarm Number (4000 to 4999)
Alarm List-926
Other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
4940 MOTION COMMAND
CODE ERROR (SV)
Software operation error
occurred
(1)Reset the alarm.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
4941 CANNOT EXECUTE
MOTION CMD (SV)
Software operation error
occurred
(1)Reset the alarm.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
4942 AVERAGING TIME
CHANGE ERR (SV)
Software operation error
occurred
(1)Reset the alarm.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
4943 AVERAGING TIME
ERROR (SERVO)
Software operation error
occurred
(1)Reset the alarm.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
4944 POSITION LOOP
GAIN ERROR (SV)
Software operation error
occurred
(1)Reset the alarm.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
4945 MOTION COMMAND
DATA ERROR (SV)
Software operation error
occurred
(1)Reset the alarm.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
4946 PG POWER ON
INCOMPLETE (SV)
Software operation error
occurred
(1)Reset the alarm.
(2)If the alarm occurs again, save the CMOS.BIN in maintenance
mode, and then contact your Yaskawa representative about
occurrence status (operating procedure).
Alarm
Number
Alarm Name
Sub
Code
Meaning Cause Remedy
To Next Page
Loading...
