EasyManua.ls Logo

YASKAWA DX200 - Page 342

YASKAWA DX200
1166 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Alarm List
Alarm Number (0000 to 0999)
Alarm List-135
60 The software version of the
functional safety board
connected to the 1st servo
board is unmatched.
Software error (1)Turn the power OFF then back ON.
(2)If the alarm occurs again, check the YSF25 board version and then
consult your Yaskawa representative.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
61 The software version of the
functional safety board
connected to the 2nd servo
board is unmatched.
Software error (1)Turn the power OFF then back ON.
(2)If the alarm occurs again, check the YSF25 board version and then
consult your Yaskawa representative.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
62 The software version of the
functional safety board
connected to the 3rd servo
board is unmatched.
Software error (1)Turn the power OFF then back ON.
(2)If the alarm occurs again, check the YSF25 board version and then
consult your Yaskawa representative.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
63 The software version of the
functional safety board
connected to the 4th servo
board is unmatched.
Software error (1)Turn the power OFF then back ON.
(2)If the alarm occurs again, check the YSF25 board version and then
consult your Yaskawa representative.
other If the alarm occurs again, save the CMOS.BIN in maintenance mode,
and then contact your Yaskawa representative about occurrence
status (operating procedure).
64 The software version of the
functional safety board
connected to the 5th servo
board is unmatched.
Software error (1)Turn the power OFF then back ON.
(2)If the alarm occurs again, check the YSF25 board version and then
consult your Yaskawa representative.
Alarm
Number
Alarm Name
Sub
Code
Meaning Cause Remedy

Table of Contents

Other manuals for YASKAWA DX200

Related product manuals