YASKAWA FSDrive-MV1000 Series - Page 205

6.6 Replacing Power Cells
YASKAWA ELECTRIC TOEP C710687 02B FSDrive-MV1000 Instructions 205
Periodic Inspection & Maintenance
6
Figure 6.5
Figure 6.6
Figure 6.5 Drawing Out a Power Cell
7. Secure the Power Cell on the platform with a belt or other means to prevent falling and move the Power Cell to a
stable position.
Figure 6.7
Figure 6.8
Figure 6.6 Moving A Power Cell
Figure 6.9
Figure 6.10
Figure 6.7 Safety Rails to Prevent the Power Cell from Falling
Note: Safety rails to prevent the Power Cell from falling are removable. Insert the rails according to the position of the Power Cell.
A – Drive D – Fix the lifter at the appropriate height for
the Power Cell.
B – Power Cells E – Pull the Power Cell out about 100 mm
toward front.
C – Lifter F – Safety rail to prevent the Power Cell
from falling (provided with lifter)
A – Drive C – Belt to prevent the Power Cell
from falling
B–Lifter
A – Lifter (bucket) C – Position to insert safety
rails
B – Two safety rails to prevent
the Power Cell from falling
(provided with lifter)
C
C
D
D
A
A
E
E
F
B
B
＜
Power Cell Placed Horizontally
＞＜
Power Cell Placed Vertically
＞
Asia
B
B
C
C
A
A
＜
Power Cell Placed Horizontally
＞＜
Power Cell Placed Vertically
＞
Asia
A
B
C
C
Asia