Docu ment No. E ZZ024048<1>
Pr epared in October, 2021
7 / 19
◼ Se t Monitor to Log
The procedure in this section shows how to set the monitor for which to log data.
1. Push (Home) to show the HOME screen.
Note: When the drive is in HOME Mode, the screen shows [Home] in the upper right-
hand corner of the screen.
If the screen does not show [Home] for , push (Back), and then push
to show [Home].
2. Push (Menu).
3. Push or to select [Diagnostic Tools], then push .
4. Push or to select [Data Logger], then push (Setup).
5. Push or to select [Log Monitor], then push .
6. Push or to select the save-destination monitor parameter, then push .
Note: The quantity of log monitor data that can be set depends on the type of data log.
7. Push or to select the monitor number to be logged, then push .
The configuration procedure is complete.
To Next Page
Loading...
