YASKAWA GA700 - Verify Keypad Parameters and Drive Parameters

Startup Procedure and Test Run
3
3.6 Keypad Operation
YASKAWA ELECTRIC SIEP C710617 05F YASKAWA AC Drive GA700 Technical Manual 171
6. Push or to select the backed-up parameter data, then push .
The keypad will show the "End" message when the write process is complete.
Note:
Different settings and conditions will change the keypad display.
A - A1-02 [Control Method Selection]
settings
B - o2-04 [Drive Model (KVA)
Selection] settings (2 or 3 digits)
C - Presence of DriveWorksEZ
parameter backup
D - Parameter backup data is not
registered
E - Backup data does not contain the
date Information
F - Backup date
◆ Verify Keypad Parameters and Drive Parameters
This procedure verifies that the parameter setting values that were backed up in the keypad agree with the
parameter setting values in the drive.
Note:
• Always stop the drive before you start to verify the parameters.
• The drive does not accept Run commands while restoring parameters.
1. Push (Home) to show the HOME screen.
Note:
• The keypad will show [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on , push (Back) to show [Home] on .
2. Push (Menu).
3. Push or to select [Parameter Backup/Restore], then push .