Parameter List
10
10.5 b: Application
YASKAWA ELECTRIC SIEP C710617 05F YASKAWA AC Drive GA700 Technical Manual 507
◆ b5: PID Control
No.
(Hex.)
Name Description
Default
(Range)
Ref.
b5-01
(01A5)
PID Mode Setting
Sets the type of PID control.
0 : Disabled
1 : Standard
2 : Standard (D on feedback)
3 : Fref + PID Trim
4 : Fref + PID Trim (D on feedback)
5 : Same as 7series & prior, b5-01=1
6 : Same as 7series & prior, b5-01=2
7 : Same as 7series & prior, b5-01=3
8 : Same as 7series & prior, b5-01=4
Note:
Use settings 5 to 8 when the drive is a replacement for a previous
generation drive.
0
(0 - 8)
729
b5-02
(01A6)
RUN
Proportional Gain
(P)
Sets the proportional gain (P) that is applied to PID input.
1.00
(0.00 - 25.00)
730
b5-03
(01A7)
RUN
Integral Time (I)
Sets the integral time (I) that is applied to PID input.
1.0 s
(0.0 - 360.0 s)
730
b5-04
(01A8)
RUN
Integral Limit
Sets the upper limit for I control as a percentage of E1-04
[Maximum Output Frequency].
100.0%
(0.0 - 100.0%)
730
b5-05
(01A9)
RUN
Derivative Time
(D)
Sets the derivative time (D) for PID control. This parameter adjusts
system responsiveness.
0.00 s
(0.00 - 10.00 s)
730
b5-06
(01AA)
RUN
PID Output Limit
Sets the maximum possible output from the PID controller as a
percentage of E1-04 [Maximum Output Frequency].
100.0%
(0.0 - 100.0%)
731
b5-07
(01AB)
RUN
PID Offset
Adjustment
Sets the offset for the PID control output as a percentage of E1-04
[Maximum Output Frequency].
0.0%
(-100.0 - +100.0%)
731
b5-08
(01AC)
Expert
PID Primary Delay
Time Constant
Sets the primary delay time constant for the PID control output.
Usually it is not necessary to change this setting.
0.00 s
(0.00 - 10.00 s)
731
b5-09
(01AD)
PID Output Level
Selection
Sets the polarity of the PID output.
0 : Normal Output (Direct Acting)
1 : Reverse Output (Reverse Acting)
0
(0, 1)
731
b5-10
(01AE)
RUN
PID Output Gain
Setting
Sets the amount of gain to apply to the PID output.
1.00
(0.00 - 25.00)
731
b5-11
(01AF)
PID Output
Reverse Selection
Sets the function that enables and disables reverse motor rotation for
negative PID control output.
0 : Lower Limit is Zero
1 : Negative Output Accepted
0
(0, 1)
731
To Next Page
Loading...
