11.8 H: Terminal Functions
880 YASKAWA ELECTRIC SIEP C710617 05F YASKAWA AC Drive GA700 Technical Manual
■ 60: DC Injection Braking Command
Setting Function Description
60 DC Injection Braking
Command
Sets the command to use DC Injection Braking to stop the motor.
If you input the Run command or JOG command, it will cancel DC Injection Braking.
Figure 11.87 shows the DC Injection Braking function:
Figure 11.87 DC Injection Braking Time Chart
Note:
• When A1-02 = 8 [Control Method Selection = EZ Open Loop Vector Control], this function is available if you use a PM motor.
• Refer to “b2: DC Circuit Braking” for more information.
■ 61: Speed Search from Fmax
Setting Function Description
61 Speed Search from
Fmax
Sets the function to start speed search using an external reference although b3-01 = 0 [Speed
Search Selection at Start = Disabled].
When the terminal is turned ON for b3-24 = 2 [Speed Search Method Selection = Current Detection 2], the drive
starts speed search from the maximum output frequency.
Note:
• The drive will detect oPE03 [Multi-Function Input Setting Err] when H1-xx = 61 and 62 are set at the same time.
• Refer to “b3: Speed Search” for more information.
■ 62: Speed Search from Fref
Setting Function Description
62 Speed Search from
Fref
Sets the function to start speed search using an external reference although b3-01 = 0 [Speed
Search Selection at Start = Disabled].
When the terminal is turned ON for b3-24 = 2 [Speed Search Method Selection = Current Detection 2], the drive
starts speed search from the frequency reference.
Note:
• The drive will detect oPE03 [Multi-Function Input Setting Err] when H1-xx = 61 and 62 are set at the same time.
• Refer to “b3: Speed Search” for more information.
■ 63: Field Weakening
Setting Function Description
63 Field Weakening
Sets the function to send the Field Weakening Level and Field Weakening Frequency Limit
commands set in d6-01[Field Weakening Level] and d6-02 [Field Weakening Frequency Limit]
when the input terminal is activated.
Note:
Refer to “d6: Field Weak & Field Force” for more information.
To Next Page
Loading...
