16 Disposal Instructions
YASKAWA TOEPC7106170VA GA800 600 V Drive Installation & Primary Operation 65
• A problem with an external device.
• The external wiring has a short circuit or is disconnected.
• There is damage to the device.
Find the cause and repair the problem to correctly display the status.
3. Make sure that the EDM signal operates during usual operation as shown in Table 15.2.
16 Disposal Instructions
Correctly discard the drive, packing material, battery, and microSD card as specified by regional, local, and municipal
laws and regulations for this product. (Example: European Waste 16 02 14)
Note:
• Remove the battery and microSD card from the keypad before you discard the drive.
• You cannot recycle the battery. Discard used batteries as specified by the battery manufacturer.
• Customers are responsible for microSD card data protection. PC functions that format and delete the data may not be sufficient to fully
erase the microSD card data.
Yaskawa recommends that customers physically destroy the microSD card in a shredder or use data wipe software to fully erase the card.
◆ WEEE Directive
The wheelie bin symbol on this product, its manual, or its packaging identifies that you must recycle it at the end of
its product life.
You must discard the product at an applicable collection point for electrical and electronic equipment (EEE). Do not
discard the product with usual waste.
17 Maintenance
Only let authorized persons do maintenance, examine, or replace components on the drive.
Read this manual carefully and know all the precautions and safety information before installing, wiring, repairing, or
examining the drive or replacing components.
Examine and maintain the drive and peripheral devices regularly to extend the life of the drive and decrease
performance deterioration, decrease early wear, and decrease drive failures.
Regular examinations and maintenance will also decrease system downtime.
Refer to the Technical Reference (SIEPC7106170V) for more information about maintenance and examinations.
Examine the drive one time each year at a minimum.
The operating conditions, environmental conditions, and use conditions will have an effect on the examination
frequency for connected equipment.
Examine the drive more frequently if you use the drive in bad conditions or in these conditions:
• High ambient temperatures
• Frequent starting and stopping
• Changes in the AC power supply or load
• Too much vibration or shock loading
• Dust, metal dust, salt, sulfuric acid, or chlorine atmospheres
• Unsatisfactory storage conditions
To Next Page
Loading...
