YASKAWA iQpump1000 - LCD Display

u
LCD Display
Figure 4.3 LCD Display
Table 4.3 Display and Contents
No. Name Display Content
1 Operation Mode Menus
MODE Displayed when in Mode Selection.
QMONI:
Use F1/F2
Instructions to access the Quick Monitors.
MENU: Use
UP/DWN
Instructions to access the next menu item.
MONITR Displayed when in Monitor Mode.
VERIFY Indicates the Verify Menu.
PRMSET Displayed when in Parameter Setting Mode.
A.TUNE Displayed during Auto-Tuning.
SETUP Displayed when in Setup Mode.
2 Mode Display Area
DRV Displayed when in Drive Mode.
PRG Displayed when in Programming Mode.
3 Ready Rdy Indicates the drive is ready to run.
4 Data Display — Displays specific data and operation data.
5
Frequency
Reference
Assignment
<1>
OPR Displayed when the frequency reference is assigned to the HOA keypad.
COM
Displayed when the frequency reference is assigned to the MEMOBUS/Modbus Communication
Inputs of the drive.
OP Displayed when the frequency reference is assigned to option card connected to the drive.
AI Displayed when the function reference is assigned to an analog input.
OFF Displayed when HAND mode is OFF.
6
LOCAL/REMOTE
Display
<2>
RSEQ
Displayed when the Run command is supplied from a remote source.
Note: This display will blink when b1-02 is set to 1 (Digital Inputs).
LSEQ Displayed when the Run command is supplied from the HOA keypad.
RREF
Displayed when the Run command is supplied from a remote source.
Note: This display will blink when b1-01 is set to 1 (Analog Inputs).
LREF Displayed when the Run command is supplied from the HOA keypad.
4.3 Using the HOA Keypad
112
YASKAWA TOEP YAIP1W 01A YASKAWA AC Drive - iQpump1000 Quick Start Guide