HOA Keypad Display Error Name
oPE29 Geothermal Set Error
Cause Possible Solutions
P1-01 parameter selection is not compatible with
Geothermal Mode (b1-01 = 5).
Confirm b1-01 and P1-01 parameter settings.
HOA Keypad Display Error Name
oPE30 Flow Meter Input Error
Cause Possible Solutions
Analog and pulse flow meters are programmed
simultaneously.
H6-01 is set to 5 and either H3-02, H3-06, or H3-10
is set to 22.
Reprogram H6-01, H3-02, H3-06, or H3-10.
Flow meter scaling is set to 0 and the flow meter
is being used as PID feedback.
P6-01 is set to 0.0, P1-02 is set to 25 and b5-01 is
set to a value higher than 0.
Reprogram P6-01, P1-02, or b5-01.
HOA Keypad Display Error Name
oPE31 Water Level/Suction
Cause Possible Solutions
Both Q4-01, Water Level Selection, and Q5-01,
Suction Pressure Select, are set to a non-zero value.
Reprogram Q4-01 or Q5-01.
HOA Keypad Display Error Name
oPE32 Incompatible Network Water Level/Suction Pressure Mode
Cause Possible Solutions
Low Water Level or Suction Pressure Turn-Off
Method (P9-51) is restricted to Water Level Source
of Analog Only (P9-50 = 0).
Confirm parameter settings for P9-50 and P9-51.
HOA Keypad Display Error Name
oPE33 Parameter selection is incompatible with the selected network P9-99
Cause Possible Solutions
When P1-01 = 3 (MEMOBUS Networking) and
P9-99 = 0 (A-Version 30034), one of the following
parameters has been set:
• P9-01 = 2 (Stop History)
• P9-05 = 3 (Follow Lead Speed)
• Q4-01 > 0 (Water Level Enabled)
• Q5-01 > 0 (Suction Pressure Control Enabled)
• P6-01 > 0 (Flow Meter Enabled) and P9-40 = 3
(Network)
Confirm parameter settings for P1-01, P9-99, P6-01, P9-05, P9-40, Q4-01, and Q5-01.
5.4 Operator Programming Errors
206
YASKAWA TOEP YAIP1W 01A YASKAWA AC Drive - iQpump1000 Quick Start Guide
To Next Page
Loading...
