JVOP-181 USB Copy Unit (Y-Stick)
Driver Installation Guide
IG.V1000.01 12/11/2007
Installing the JVOP-181 USB Copy Unit (Y-Stick) Driver
To install the driver, please follow the steps below;
1. Copy the driver to a folder located on the PC such as “My Documents”.
2. Insert the USB connector from the JVOP-181 Copy Unit into an available
USB port on the PC.
3. The PC will recognize the new hardware and will display the Hardware Wizard
shown below.
4. Follow the Hardware Wizard and select “Install from a list or specific location (Advanced)
then select “Next”.
To Next Page
