Technical data
6 - 34
6.4.1 Instructions for Installing the Mechanical Limit
• Mount the mechanical limit of S axis so that as shown in the figure "Components of the
S axis limit".
• When inserting the pin in the limit, apply Loctite 242 on the screw-on surface of the pin.
• Fasten the dog on the S-head using 3 screws M20 x 40 (Strength category 12.9).
Tighten the screws with a tightening torque of 700 Nm.
• With a working area of ±180°, the stop must be mounted (as shown in the figure
"Components of the S axis limit").
• The stop can be mounted at 15-degree intervals. To avoid a mechanical interference
from stop duplication (eg ± 15°, ± 165°), install the mechanical stop as shown in the
following table 6.4.3 "Adjusting the S-Axis Pulse Limit".
NOTICE
Always use the specified components when installing the S-axis limit
Switch OFF the supply voltage before you start mounting.
See chapter 6.4.3 "Adjusting the S-Axis Pulse Limit" at page 36.
To Next Page
Loading...
