2 Examples of Use of Relative Jobs
DX100 2.3 Using One Job on Multiple Manipulators
2-6
156191-1CD
HW0482494
2.3 Using One Job on Multiple Manipulators
Fig. 2-2: Using One Job on Multiple Manipulators
A job taught to one manipulator can be used for other manipulators on the
line.
1. On manipulator No.1, create a job for a single workpiece.
2. Teach a user coordinate system (for instance, UF#1) for the workpiece
in that location.
3. Convert the job created in step 1 into a relative job using the user
coordinate system taught in step 2.
4. Save the created relative job in an external memory device.
5. Set workpieces to manipulators No. 2 and No. 3 to which the job will
be shifted. Teach the user coordinate system (UF#1) to the
manipulators.
6. Load the relative job saved in step 4 and convert it to standard jobs for
manipulators No. 2 and No. 3.
– This operation creates jobs operated at the posture specified in
step 5.
The manipulator is not always capable of carrying out the
operation depending on the operating position.
Check the positions by FWD and BWD operations.
No.1 No.2 No.3
Manipulator
Workpiece
To Next Page
Loading...
