YASKAWA Motoman DX200 - Deleting the Shift Data and the Data of Conveyor Synchronized Section

5-19
165553-1CD
HW1482183
5 Conveyor Monitoring Displays for the Shift Functions
5.5 CV SHIFT MONITOR display
Conveyor Synchronized
Funciton with Shift
Functions
5.5.4 Deleting the Shift Data and the Data of Conveyor Synchronized
Section
Delete the shift data and the data of conveyor synchronized section at a
time in the following manner.
Press the area key  Select {DATA}  Select “ALL CLEAR”
1)
 Move the cursor
to “YES” and press [ENTER]
1 The following display appears.
NOTE
While power is supplied to the DX200, the DX200 manages
and updates automatically all the conveyor data regardless
of the operation mode. Accordingly, deleting data while the
conveyor is moving does not cause a problem. However, it
may cause a malfunction due to inconsistency between the
actual conveyor status and the DX200 conveyor data in the
following cases:
- The conveyor moves while power is not supplied to the
DX200 or during the DX200 start sequence.
- A momentary power failure occurs during operation in play
mode.
- The virtual conveyor mode is set with the setting
“Ignorance of shift distance in virtual mode.”
89 of 98