YASKAWA MOTOMAN-ES200RD II - Grease Exchange; Grease Replenishment; Grease Replenishment;Exchange for S-Axis Speed Reducer and Gear

9-8
170625-1CD
HW1482737
ES200RD II
9 Maintenance and Inspection
9.3 Grease Replenishment/Exchange
9.3.2 Grease Replenishment/Exchange for S-Axis Speed Reducer and Gear
Fig. 9-4: S-Axis Speed Reducer and Gear Diagram
9.3.2.1 Grease Replenishment
(Refer to Fig. 9-4 “S-Axis Speed Reducer and Gear Diagram”.)
1. Remove the hexagon socket head plugs from the grease inlet and
grease exhaust port.
2. Install a grease zerk A-PT1/4 to the grease inlet.
(The grease zerk is delivered with the manipulator.)
3. Inject grease through the grease inlet using a grease gun
– Grease type: Molywhite RE No. 00
–
Amount of grease: 1200 cc
(2400 cc for 1st supply)
– Air supply pressure of grease pump: 0.3 MPa or less
– Grease injection rate: 8 g/s or less
4. Move the S-axis for a few minutes to discharge excess grease.
5. Wipe the discharged grease with a cloth, and reinstall the plug. Before
inst
alling the plug, apply Three Bond 1206C on the thread part of the
plug. Then tighten the plug with a tightening torque of 4.9 N•m
(0.5 kgf•m).
6. Remove the grease zerk from the grease inlet, and reinstall the plug.
Before inst
alling the plug, apply Three Bond 1206C on the thread part
of the plug. Then tighten the plug with a tightening torque of 4.9 N•m
(0.5 kgf•m).
Grease inlet
Hexagon socket head plug PT 1/4
S-axis speed reducer
Grease exhaust port
Hexagon socket head plug PT1/8
NOTE
If grease is injected with the plug on, grease will leak inside
the motor and may cause a damage. Make sure to remove
the plug before the grease injection.
63 of 100