5 Disassembly and Reassembly of the Motor
5.3 Disassembly and Reassembly of the U-Axis Motor
5-14
HW1484673
HW1484673
Fig. 5-5(b): Surface to Apply Sealing Bond on the U-Axis Motor
Fig. 5-5(c): Removing the Key and Gear
Fig. 5-5(d): Motor Power Cable
Apply sealing bond evenly to whole surface.
Surface to apply sealing bond 2
Surface to apply sealing bond 1
Put the flat head screw driver into the hole of the side of
the gear and tilt it in the direction of the arrow mark to
make a space between the shaft and the motor.
1
Put the flat head screw driver into a space between
the gear and the motor, and tilt it in the direction of
the arrow to remove the shaft.
2
Main key
Coupling nut
Alignment mark
To Next Page
Loading...
