YASKAWA Motoman GP50 - Applying Sealing Bond to Sealing Surface

4 Notes on Grease Replenishment/Exchange Procedures
4.2 Removing, Applying, Assembling of Sealing Bond
4-8
HW1484673
HW1484673
4.2.2 Applying Sealing Bond to Sealing Surface
1. Check that the degreasing and cleaning agent of the sealing surface is
dried. (Refer to fig. 4-4 “Checking the Dryness” .)
If not dried, wipe the agent with a new cloth. (Refer to fig. 4-5 “Wiping
the Agent” .) For the part where wiping cannot be performed such as
the concave part, use air to blow off.
2. Apply ThreeBond 1206C to the sealing surface.
Fig. 4-4: Checking the Dryness
Fig. 4-5: Wiping the Agent
NOTE
The points to apply sealing bond depend on the axes.
When applying sealing bond, make sure to refer to
chapter 5 “Disassembly and Reassembly of the Motor”
and chapter 6 “Disassembly and Reassembly of the Speed
Reducer” of each axis.
31/109