5 Disassembly and Reassembly of the Motor
5.4 Disassembly and Reassembly of the R-Axis Motor
5-17
HW1484673
HW1484673
Fig. 5-6(b): Surface to Apply Sealing Bond on the R-Axis Motor
Fig. 5-6(c): Removing the Key and Gear
Fig. 5-6(d): Motor Power Cable
Apply sealing bond here.
Apply sealing bond evenly to whole surface.
Put the flat head screw driver into the hole of
the side of the gear and tilt it in the direction of
the arrow mark to make a space between
the shaft and the motor.
1
Put the flat head screw driver into a space between
the gear and the motor, and tilt it in the direction of
the arrow to remove the shaft.
2
Main key
Coupling nut
Alignment mark
To Next Page
Loading...
