1 Introduction
1-6
HW1484673
HW1484673
Explanation of Warning Labels
The following warning labels are attached to the manipulator.
Always follow the warnings on the labels.
Also, an identification label with important information is placed on the
body of the manipulator. Prior to operating the manipulator, confirm the
contents.
Note: Taking the maintenance-relevant trainings offered by YASKAWA is
indispensable for replacing the L-axis of the balancer-equipped
manipulator.
Fig. : Warning Label Locations
Crush hazard label
Fall down hazard label
Collision
hazard label
NJ4040
MADE IN JAPAN
YASKAWA ELECTRIC CORPORATION
Kitakyushu 806-0004 Japan
2-1 Kurosakishiroishi, Yahatanishi-ku,
MASS
kg
TYPE
PAYLOAD
NJ4030
SERIAL NO.
DATE
kg
15
NJ4032
ＵＴＴＡＨ－Ｂ２０ＲＪ
ＡＢＳ． ＥＮＣＯＤＥＲ
ＵＴＴＡＨ－Ｂ２０ＲＪ
ＡＢＳ． ＥＮＣＯＤＥＲ
ＵＴＴＡＨ－Ｂ２０ＲＪ
ＡＢＳ． ＥＮＣＯＤＥＲ
NJ4036
M4
M4
ＵＴＴＡＨ－Ｂ２０ＲＪ
ＡＢＳ． ＥＮＣＯＤＥＲ
ＵＴＴ
Ａ
Ｈ－Ｂ２０ＲＪ
ＡＢＳ
．
Ｅ
ＮＣ
ＯＤＥ
Ｒ
Nameplate
Nameplate
MADE IN JAPAN
YASKAWA ELECTRIC CORPORATION
Kitakyushu 806-0004 Japan
2-1 Kurosakishiroishi, Yahatanishi-ku,
MASS
kg
TYPE
PAYLOAD
NJ4030
SERIAL NO.
DATE
kg
To Next Page
Loading...
