YASKAWA Motoman GP8 EduCart - Configuration Of The Programming Pendant; Setting Up I;F Panel

6-1
186638-1CD
186638-1CD
6 Configuration Of The Programming Pendant
6.1 Programming Pendant
GP8 EduCart
6 Configuration Of The Programming Pendant
6.1 Programming Pendant
1. Press the {I/F Panel} on the Programming Pendant display.
2. Place the “OPERATION” switch to “PERM” by pressing the
[INTERLOCK] key on the keypad and pressing the “OPERATION”
switch on the display of the Programming Pendant.
3. To set up an interface with the “Input *** Control” switch press the
[INTERLOCK] key on the keypad and pressing the “Input *** Control”
switch on the display of the Programming Pendant and observe the
input status changes.
52 of 88