YASKAWA Motoman HP165-100 - Grease Replenishment for Balancer Connection Part

9.2 Notes on Maintenance Procedures
9-20
HW0481994
9.2.6 Grease Replenishment for Balancer Connection Part
Fig. 28 Balancer Connection Part
1. Remove the hexagon socket head plugs PT1/8 of connection  and . (Refer to " Fig.
28 Balancer Connection Part ".)
2. Inject grease into grease inlets of connection  and  using a grease gun.
3. Reinstall the plugs PT1/8 of connection
1 and 2. Tighten the plugs with a tightening
torque of 5 N・m (0.51kgf・m). (Apply Three Bond 1211 to the screwed part of the
plug.)
Grease type: Alvania EP grease 2
Amount of grease: 5 cc
(10 cc for 1st supply)
The exhaust port is used only for air flow.
Do not inject excessive grease into the gear grease inlet.
Hexagon socket head plug PT1/8
Hexagon socket head plug PT1/8
Connection 2 Grease inlet
Exhaust port
2
Grease zerk A-PT1/8
Connection 1 Tapered roller bearing
(2 bearings)
Grease zerk A-PT1/8 (2 grease zerks)
Connection
1 Grease inlet
Connection
2 Needle bearing
Exhaust port 1
NOTE
60/76