YASKAWA MOTOMAN-MFL15D-875 - Checking the Order Number; Precautions on Unpacking

1 Receiving
1.2 Checking the Order Number
1-2
179394-1CD
HW1483905
MFL15D-875/-1600
1.2 Checking the Order Number
Check that the order number of the manipulator corresponds to the
DX200. The order number is located on a label as shown below.
Fig. 1-1: Location of Order Number Labels
1.3 Precautions on Unpacking
Unpack the equipment in a clean room. If in any place other than a clean
room, unpack the manipulator after removing dust with an air blower.
THE MANIPULATOR AND THE CONTROLLER
SHOULD HAVE SAME ORDER NUMBER.
ORDER. No.
O
T
P
S
E
R
M
E
E
G
N
Y
C
E
T
E
S
R
F
F
O
D
E
P
P
I
R
T
N
O
DX200 MFL15DN
඲䛶䛾䝗䜰䝻䝑䜽䜢☜ᐇ䛻㛢䜑䛶ୗ䛥䛔䚹
NJ3005-1
CHECK ALL THE DOOR LOCKS
PROPERLY.
PROGRAMMING PENDANT
X 8 1
ឤ㟁䛾ᜍ䜜䛒䜚
㏻㟁୰䚸ᡬ䜢㛤䛡䜛䛺
༴䚷㝤
MADE IN JAPAN
AC220V
DATE
SERIAL No.
50/60Hz
NJ3523-1
3PHASE
kVA
TYPE
POWER SUPPLY
INTERRUPT CURRENT
kA
AVERAGE
ERMR-
APPROX MASS
FULL LOAD CURRENT
A
AC200V50/60Hz
kg
DOCUMENT No.
NJ1529
䜸䞊䝎䛾ྠ୍NO.䛸᥋⥆䛧ᚚ౑⏝㢪䛔䜎䛩䚹
Motomanᮏయ䛸YASNAC䛿䚸ୗグ
ORDER NO.
(b) Manipulator (Top View)(a) DX200 (Front View)
Label (Enlarged View)
Check that the manipulator
and the DX200 have the
same order number
.
NOTE
Operating the manipulator in an environmental clean room
of a lower class may lower the cleanliness class of the
manipulator.
16 of 74