7 Configuration and Maintenance of MLX200 Control Module
7.2 Maintenance and Configuration Operations
7-6
168542-1CD
168542-1CD
MLX200 Software and
Operations
Fig. 7-7: Maintenance Operations Screen of MLX200 Control Module
The user can now select a category of operation on the left, then select a
specific operation in the middle within that category and then click the
[Execute] button to perform the operation. The message display area in
the bottom will display status and instructions regarding each operation.
The user can click on the [Close] button to return to the {Status Display}
screen.
7.2.2 Changing the Password of the MLX200 Control Module
The password required to perform maintenance operations on the
MLX200 Control Module can be changed through the following procedure.
Click on the “Settings” category in the {Maintenance} screen and select
“Change IP Address” from the list of operations as shown in Fig.7-8
"Selecting the Change Password Operation".
Fig. 7-8: Selecting the Change Password Operation
To Next Page
Loading...
