YASKAWA MOTOMAN-MPX2600 - Pressure Switch Unit

4-15
180788-1CD
HW1484370
4 Wiring
4.3 Requirements
MPX2600
4.3.1 Pressure Switch Unit
The pressure switch unit supplies protective air or gas to the manipulator
to prevent explosive gas from entering the manipulator. Usually, the unit is
installed on the side of the DX200.
The circuit diagram and dimensions are shown in
Fig. 4-10 “Electrical/Air
Circuit of the Pressure Switch Unit”
.
Set the air pressure so that the pressure shown on the pressure gauge of
each pressure reducing valve to be within the pressure ranges shown in
fig. 4-10.
Fig. 4-10: Electrical/Air Circuit of the Pressure Switch Unit
Intrinsically safe
terminal block
320 L/min
20 kPa
50 kPa
5 kPa
Pressure switch unit
Mnipulator
AV1
SV1
Master Valve
Purge
pressure regulator
Operating pressure, purge
pressure switch solenoid valve
Operating
pressure regulator
Pressure control solenoid valve
(0.18 to 0.20 MPa)
(0.01 to 0.02 MPa)
Industorial
compressed air
55 of 116