56 E1101000117GB01
MYS450L
We recommend that the bolts aligned on a circumference should be fastened in a crisscross
pattern as shown in the figure below.
Do not fasten all bolts securely at one time. Tighten the bolts with two or three moves. Use it
a hex wrench.
Then, use a torque wrench so that the bolts are fastened with tightening torques shown in the
table above.
Table 15: Tightening torque
Set screw Tightening torque
M4 245 Ncm
M5 3920 Ncm
Screw Tightening torque
1 - 8 Bolt hole
1
5
7
2
6
8
To Next Page
Loading...
