10.2 Addition of Base and Station Axis
10-22
1 The MECHANICAL SPEC window (In case of BALL-SCREW
type)
MOTION RANGE: Input maximum moving position (+ direction
and - direction) when setting home position to
0. (Unit: mm)
REDUCTION RATIO: Input the numerator and the denominator.
<e.g.> If the reduction ratio is 1/2, the numera-
tor should be set as 1.0 and the
denominator should be set as 2.0.
BALL-SCREW PITCH :Input the traveling length when the ball-
screw rotates once. (Unit: mm/r)
The MECHANICAL SPEC window (In case of RACK&PINION
type)
MOTION RANGE: Input maximum moving position (+ direction
and - direction) when setting home position to
0. (Unit: mm)
REDUCTION RATIO: Input the numerator and the denominator.
<e.g.>If the reduction ratio is 1/120, the
numerator should be set as 1.0 and the
denominator should be set as 120.0.
PINION DIAMETER: Input the diameter of a pinion. (Unit: mm)
2 Change the setting contents.
Operation Explanation
Main Menu ShortCut
EDIT
DISPLAY
UTILITY
DATA
MECHANICAL SPEC
1
AXIS TYPE
MOTION RANGE (+)
MOTION RANGE (−)
Maintenance Mode
: UNIV-3
: BALL-SCREW
REDUCTION RATIO (NUMER)
REDUCTION RATIO (DENOM)
BALL-SCREW PITCH
AXIS :1
0.000 mm
0.000 mm
1.000
2.000
10.000 mm/r
Group, Type, Axis Number
and Axis Type selected
currently are shown.
The cursor is reversed.
Main Menu ShortCut
EDIT
DISPLAY
UTILITY
DATA
MECHANICAL SPEC
1
AXIS TYPE
MOTION RANGE (+)
MOTION RANGE (−)
Maintenance Mode
: UNIV-3
: RACK & PINION
REDUCTION RATIO (NUMER)
REDUCTION RATIO (DENOM)
PINION DIAMETER
AXIS :2
0.000 mm
0.000 mm
1.000
120.000
100.000 mm
Group, Type, Axs Number
and Axis Type selected
currently are shown.
The cursor is reversed.
To Next Page
Loading...
