4.2 Addition of Base and Station Axis
4-21
When the data, motion range for example, should be changed after the addition of a
base axis or station axis, the change can be done in the same procedure as shown
above.
In that case, the control group construction is not changed so the job file data should
not be initialized.
If the control group construction is changed by addition of a base axis or station axis, the
internal data of the job file are also changed so that the job file data should be initialized.
Initialize the job file data with procedure “File Initialize” in this manual after changing the
construction.
CAUTION
To Next Page
Loading...
