System Setup
9 - 151
the DETAIL EDIT window.
2) Move the cursor to “UNUSED” of any “SENS(AXIS)” to change the detection level, and
press [SELECT].
3) The selection box appears, and select “AXIS=”.
4) Press [ENTER] after adding the items.
5) The JOB CONTENT window appears, after closing the DETAIL EDIT window.
• When changing the shock detection level for the each axis
1) When changing the shock detection level for the each axis, move the cursor to the
shock detection level; hold down [SHIFT] and press the up/down cursor key to change
the level.
• When the value is input with the numeric key
1) When the value is input with the numeric key, press [SELECT] to display the input buffer
line.
2) Input the numbers, and then press [ENTER]. The value in the input buffers is changed.
5. Press [INSERT] then [ENTER].
– The instruction displayed in the input buffer line is registered.
• SHCKRST
1. Move the cursor to the line immediately before the position at which the SHCKRST
instruction is to be registered.
To Next Page
Loading...
