System Setup
9 - 163
5. Select “BASIC COORDINATE”.
Select the base coordinate/user coordinate for the basic coordinate
NOTICE
The user coordinates number which is not yet registered or currently selected cannot be
selected.
Also, the user coordinates number which uses another user coordinates as the basic
coordinates cannot be selected.
When the user coordinate is selected for the basic coordinate, “(● REGISTERED
STATUS)” or “(○ UNREGISTERED STATUS)” is shown.
● Indicates the user coordinates number which is fully registered.
○ Indicates the user coordinates number which is not yet registered.
NOTICE
If the user coordinates which specify another user coordinates number in unregistered
status as the basic coordinates are used, the alarm no. 4508 “SPECIFIED
ERROR(COORDINATE) [18]” occurs.
To select the user coordinates for the basic coordinates, specify the registered user
coordinates number as the basic coordinates.
6. Select the item to be set and input the number.
Input the amount of change from the basic coordinate.
To Next Page
Loading...
