System Setup
9 - 214
• Setting procedures
The setting procedures are described as follows.
1. Change the security mode to the management mode.
2. Select {PM} in the main menu.
3. Select {PM(REDUCER)}.
– The lifetime calculation window appears.
4. Select {Display} in the menu.
– The {=SETUP CONDITION} appears in the pull down menu.
Torque average value Average value (average value of the av-
erage period).
Average period (30 days)
Prior to 60 days from the day to diag-
nose.
Latest period (5 days)
Prior to 90 days
Latest value (average of the nearest
value)
Prior to 60 days
When the measured value is greater
than the threshold value, it outputs the
warning.
A day to diagnose
………
1
2
3
4
5
6
7
8 9
10
1
6
2
7
3
8
4
9
5
10
To Next Page
Loading...
