System Setup
9 - 223
3. Select {=INSPECTION NOTICE}.
– The inspection notice window appears.
4. Select {Display} in the main menu.
– {=SETUP CONDITION} is displayed in the pull down menu.
5. Select {=SETUP CONDITION}.
– {=SETUP CONDITION} window appears.
Modify each items if necessary
TIME
Before the remaining time to the inspection is “0”, the message is shown and the in-
spection signal is ON at the time which is set in this item. For example, if “100” is
set, the message is shown and the signal is ON 100 hours before the remaining time
to the inspection is “0”.
The time can be set in the MANAGEMENT mode.
SIGNAL
Set the general purpose output number which notifies the inspection time.
ձ
ղ
1
2
To Next Page
Loading...
