System Setup
9 - 232
7. When replaced with an used component, select {BEGINNING}.
A window to input the numerical value appears. Input the replacement date using half-
width characters like {2009.3.14}.
After that, a following confirmation dialog box appears. When replaced with an used
component, select “YES”.
8. When manually setting the approximate value to the leftover life, input the numerical
value “0 - 100%”.
9. When the numerical value displayed in the confirmation dialog box is correct, select
“YES”.
Mask of replacement time display (Signal display)
Perform the masking of the replacement time display according to the following procedures:
1. When any of the components comes to the replacement time, the message is displayed
per unit.
2. The message is also displayed per component. Invalidate the output.
After checking the components, invalidate the output.
To Next Page
Loading...
