System Setup
9 - 239
• Data Check
The number of JOB execution, playback time, moving time, IO stop time, energy saving
time are shown. Also, the lifetime of the speed reducer, the load ratio, the maximum speed,
the average speed, the maximum torque and the average torque of each axes are shown.
The data can be checked by following steps.
1. Select {=PM} in the main menu.
2. Select {JOB MONITOR}.
The JOB MONITOR window is shown.
3. Press {PAGE}.
It is possible to check the data of the date whose number corresponds to the number
of pressing {PAGE}. Modify if necessary. The data of the current day is updated with the
latest data every time a JOB is executed. For the previous data, the average values of
the day are shown. The data of the maximum 50 days can be checked.
<Example 3>The hold, the emergency stop or the alarm stop occurs during
measurement.
TEST1.JBI
NOP measurement starts
MOVJ
MOVJ measurement ends (The hold, the emergency stop or the alarm stop occurs)
END
<Example 4>The registered job (TEST1.JBI) calls another registered JOB
(TEST2.JBI) by CALL instruction or etc.
TEST1.JBI
NOP measurement starts
MOVJ
MOVJ
CALL JOB: TEST2
END measurement starts
In this case, the JOB monitor data of TEST2 is not updated.
To Next Page
Loading...
