System Setup
9 - 240
4. Move the cursor to the desired JOB name and press {OPEN}.
The JOB DIAGNOSIS window is shown. The lifetime of the speed reducer, the load
ratio, the maximum speed, the average speed, the maximum torque and the average
torque of each axes are shown.
It is possible to check the data of the date whose number corresponds to the number
of pressing {PAGE}. Modify if necessary. The data of the current day is updated with the
latest data every time a JOB is executed. For the previous data, the average values of
the day are shown. The data of the maximum 50 days can be checked.
5. Press {CLOSE}.
The JOB MONITOR window is shown again.
• Management of Data
The job monitor data can be saved by the external memory menu.
For details of the external memory menu, refer to GENERAL OPERATOR'S MANUAL
(Document no.: E1102000220XX
1
01 or higher) to chapter „External Memory Devices“.
1. Select {EX.MEMORY} in the main menu.
2. Select {SAVE}.
3. Select “SYSTEM DATA”.
4. Select “JOB MONITOR DATA”.
The selected system data is displayed with “ ”.
5. Press [ENTER].
6. Select [YES].
“JOB MONITOR DATA” is saved.
1
The XX stands for the language of the document.
To Next Page
Loading...
